26
Troubleshooting
Problems Solution
Printing or platform cannot
reach target temp or over
heat.
1.Initialize the printer.
2.Heater catridge is broken, seek replacement.
3. Cable is broken, replace the cable.
Cannot extrude plastic
1. Plastic clog the nozzle, replace new nozzle or remove
the clog.
2. The lament is too thick. Usually happens when using
lament with poor quality.Please use UP lament.
3. For some model, if PLA consistently cause problem,
switch to ABS.
Cannot detect the printer
1.Install the printer driver correctly.
2. Check for defective USB cable.
3. Restart printer and Computer
To Previous Page
Loading...
