What to do if my computer won’t detect the TierTime 3D Printer?
If your computer isn't detecting the TierTime 3D Printer, here are a few things you can try: * Ensure that the printer drivers are correctly installed. * Check the USB cable for any defects and replace it if necessary. * Restart both the printer and your computer.
Why won’t the filament extrude from my TierTime 3D Printer?
There are several reasons why the filament might not be extruding from your TierTime 3D Printer. Here are some possible causes and solutions: * Withdraw the filament from the print head, cut off the melted tip, and then reload it. * There may be plastic clogged in the nozzle; try replacing the nozzle or removing the clog. * The filament may be too thick. For quality assurance, use UP brand filament. * If you are using some printer models, PLA can present a consistent issue. Consider switching to ABS.
How to fix TierTime UP BOX+ when printing or platform cannot reach target temp or overheat?
If your TierTime 3D Printer is unable to reach the target temperature or is overheating, you can try the following: * Initialize the printer. * If the heater cartridge is broken, replace it. * If the heater cable is broken, replace it.
Detailed steps for connecting the printer to a Wi-Fi network using the software.
General| Build Volume | 255 x 205 x 205 mm |
|---|---|
| Print Technology | Fused Filament Fabrication (FFF) |
| Nozzle Diameter | 0.4 mm |
| Filament Diameter | 1.75 mm |
| Print Speed | Up to 100 mm/s |
| Heated Bed | Yes |
| Bed Leveling | Automatic |
| Enclosure | Yes |
| Weight | 20 kg |
| Supported Materials | ABS, PLA |
| Connectivity | USB, Wi-Fi |
To Next Page
