10
Automatic Nozzle Height Detection
If consistent warping still occurs after auto-leveling, this may
due to severe unleveling of the platform which exceed the
capability of auto-leveling fucntion. In this case user should
do a coarse manual leveling before auto-leveling (see next
page).
User may also level the platform without using the auto-
leveling device and nozzle detection device. Please refer
Appendix A for details.
Choose "Nozzle Height Detect" in 3D Print menu.
The print head will move toward the nozzle height
detection device and the nozzle will eventually
touch and press the metal part on the device to
make the meausrement.
The detected nozzle height value wlll be stored in
the in the machine.
To Next Page
Loading...
