SECTION : F E ATU R E S
|
44
ACC (Accessory)
This switch is reserved to operate a switched accessory item. When the
switch is pressed, the accessory will receive power; when the opposite end
is pressed, the power will turn off.
Ballast Tank Control Switches—Optional
These switches are three-position switches to fill or drain the ballast tanks.
When the top of the switch is pressed, pump will begin to fill the designated
tank. When the opposite end of the switch is pressed, the pump will begin
to empty the designated tank.
If you continue to fill the tank beyond its capacity, the excess water will
expel from the tank vent. The pump will continue to operate until the switch
is returned to the OFF (center) position. The LED will illuminate anytime the
pump is on. Make sure to return the switch to the OFF position when the
tank is filled or emptied.
BILGE (Bilge Pump)
This switch operates the bilge pump to remove excess water from the bilge
area of the boat manually. When the top of the switch is pressed, the bilge
will turn on. When the bottom is pressed, the bilge will turn off.
Your Tigé boat is equipped with an automatic bilge pump which detects
excess water accumulation and will turn the bilge pump on automatically.
The switch does not have to be on for the automatic system to work. This
switch can also be used to test the bilge pump, by listening to hear that the
pump is operating. It may not pump water unless water is present. Do not
operate the bilge pump continuously when it is dry.
Inspect the bilge area frequently for evidence of excessive water. Continuous
operation of the bilge pump can mean there is excess water in the bilge.
Test the bilge pump at regular intervals. Debris can also prevent the pump
from operating or make it operate continuously. Make sure no debris is blocking
the bilge pump float. See your Tigé Dealer if you have any questions.
BLOWER (Engine Compartment/Bilge Area Blower)
This switch operates the engine compartment ventilation blower to remove
explosive fumes from the area. When the switch is pressed, the blower will
turn on. When the opposite end is pressed, the blower will turn off. The
blower must be operated for a minimum of four minutes before starting the
engine. Also, the blower should be operated continuously when at idle or
running at slow speeds.
DANGER
Gasoline vapors can explode resulting in serious injury or death.
• Before starting engine, check the engine compartment for gasoline or
gasoline vapors, then run blower for 4 minutes.
• Run blower below cruising speed.
CRUISE CONTROL ON/OFF (Tigé SpeedSet)
This switch supplies power to operate the Tigé SpeedSet. When the switch
is pressed (on), power is supplied for the cruise control, when the opposite
end is pressed, the power will turn off.
CTSY LTS (Courtesy Lights)
This switch operates the courtesy lights. When the switch is pressed, the
lights will turn on. When the opposite end is pressed, the lights will turn off.
DOCK LTS (Docking Lights, optional)
This switch operates the docking lights. The docking lights are to be used
for docking only; DO NOT use them while cruising. When the switch is
pressed, the lights will turn on. When the opposite end is pressed, the lights
will turn off.
To Next Page
Loading...
