SECTION : F E ATU R E S
|
45
WARNING
LOSS OF CONTROL AND UNSAFE BOAT HAZARD
An emergency stop switch system that is not used or does not function
properly can cause death or serious injury. DO NOT operate the boat if
the emergency stop switch system does not function properly.
The emergency stop switch will stop the engine when the lanyard is pulled
far enough to disconnect the clip from the switch. Attach the lanyard to
the boat operator whenever the engine is running, but be aware of loss of
engine power if the switch is activated.
If the operator is thrown from the seat, or moves too far from the dash, the
lanyard will disconnect the clip from the switch, shutting off the engine.
To attach a lanyard, connect the clip to the emergency stop switch and the
hook to a strong piece of clothing on the operator, such as a belt loop.
IMPORTANT
The engine will not start unless the clip is attached to the emergency stop
switch.
The emergency stop switch can only be effective when it is in good working
condition.
Observe the following:
• DO NOT remove or modify an emergency stop switch and/or its lanyard.
• Keep the lanyard free from obstructions that could interfere with its
operation.
Check the emergency stop switch once a month for proper operation. With
the engine running, pull lanyard to pull the clip from the switch. If the engine
does not stop, see your Tigé Dealer for service immediately.
FWD TOWER (Tower Lights)
This switch is a three-position switch to operate the tower lights. Push FWD
to operate the forward lights or AFT to operate the aft lights. DO NOT use
them while cruising. The center position of the switch is off for all lights.
Horn
The “HORN” button is a momentary switch. The horn will operate when the
button is pressed and stop when the button is released.
Ignition Key Switch
This key switch starts and stops the engine. A built-in protection system
prevents the engine from starting in any gear and only in NEUTRAL. Refer
to Shifter/Throttle Control in this section and refer to the engine owner’s
manual for more information.
There is an accessory position on the ignition key switch. A terminal on the
back of the switch is provided to control power to add-on accessories. Even
though power to this terminal is protected by a 20-amp fuse, do not connect
any accessory that draws more than 10 amps. Attaching an accessory to
this terminal should only be done by a qualified technician.
NOTICE
DO NOT connect an accessory drawing more than 10 amps to the key
switch accessory terminal. A hazardous situation or damage to the
electrical system can occur.
To Next Page
Loading...
