The conversion of net efficiency to gross was achieved by multiplying the net
efficiency by the following conversion factor from Table E3 of SAP 2005, rounding
down to the nearest whole number.
3. UNPACKING
Before installation, check that the following components, where required, have been
delivered.
Loose parts box - Contains the Deflector, Flue Collar, Diverter box, 4 Feet, 2
handles of different colour, Fire bar, Lower front casting, Bottle of touch-up paint, 2
floor securing screws and plugs, Bolts and Screws.
Stove body - Contains the Stove body with Hexagonal key, Restrictor Plate and
securing bolts.
Contained in the stove body are two boxes as
below. To access these, insert the required
handle into the door latch, unlock the lock nut
at the side of the latch using the Hexagonal key
and turn the handle clockwise (See figure 1).
Box 1 - Contains the burner assembly, the flue
safety switch and leads assembly, the inlet ‘T’
connector, the control knob assembly and
burner securing screws.
Box 2 - Contains the ceramic fuel effect.
Page 7
© Baxi Heating U.K. Limited 2010.
INSTALLER GUIDE
Gas Conversion factor from net to gross efficiency
Natural Gas 0.901
LPG 0.921
Figure 1.
To Next Page
Loading...
