Tiger BLAKE - Step 10: INSTALL ROOF BOARDS; Step 11: INSTALL ROOF BATTEN AND SKIRTING

Step 10:
INSTALL ROOF BOARDS
• Beforeinstallingtheroofboards,checkthatthecabinissquarebothvercally&horizontally.
 Adjustifrequired.
• Posionatongue&grooveroofboardushwithpurlinatoneendofroof.
 • Fixthroughhighsidetoplogusing2xN65perboard..
(Detail H1)
 • Fixthroughonepurlinusing2xN65perboard.(Detail H2)
 • Fixthroughlowsidetoplogsusing2xN65perboard.(Detail H3)
• Connueworkingacrossroof,repeangthestepsabove.
• Thenalroofboardmayneedtrimmingtositushwithpurlinatend.
H1 H2 H3
N65
N65
N65
TOP TIP
Measure 175mm from the boom edge of roof board to outside of back
wall to get correct overhang on lower edge of roof.
(Detail H3)
CRITICAL!: ALL ROOF BOARDS MUST HAVE 2X N65 PER FIXING POINT AS OUTLINED ABOVE.
Pleaseretaininstruconsforfuturereference
Step 11:
INSTALL ROOF BATTEN AND SKIRTING
• Fixroofbaenontotheundersideofroofboardsonlowsideusing6xN40,evenlyspacedalonglength.
 Finishwithapieceofskirng,aachedusing6xN40,evenlyspacedalonglength.
(Detail I1 & I2)
• Fixroofbaenonlyonhighsideasshownusing6xN40,evenlyspacedalonglength.(Detail I3)
NOTE: ROOF BATTENS AND SKIRTING MAY COME IN MORE THAN 1 SECTION.
I2I1
N40
N40
I3
N40
13