ASSEMBLY
Assembly Section 2-15
Arrange the hoses in the clamp that attaches to the boom mounting bracket as shown
above, with the 1” motor hoses closest to the bracket and the return hose closest to the
boom arm. Pull the hoses snug from the swivel to the mounting bracket clamps, when
main boom is still forward, and tighten the hoses in the clamp.
Make sure the 1” motor hoses do not kink as the boom arm is moved into the stowing
position. If this happens the motor hoses will have to be shortened, because there is too
much hose between clamps.
(ASM-C-0059)
To Next Page
Loading...