Tiger MALAYAN - Step 10: Felt the Roof

Please retain instrucons for future reference
13
Step 10:
FELT THE ROOF - MEASURE AND CUT BEFORE INSTALLING FELT
• Roll felt out onto a clean at surface 30 minutes before you need it so it has a chance to aen out.
• Measure length of roof and allow 75mm overhang at each end. Cut each strip of felt to size.
Use a straight edge to guide cung.
• Roll cut felt piece along low side of roof, Secon 1, leaving sucient overhang to fold down onto roof edge.
Do not fold underneath roof.
(Detail I1 & I2)
• Once felt is rolled out, x to roof using CN20 both ends, making sure felt is straight. Secure through skirng
using CN20 at approx. 100mm intervals.
(Detail I2)
Ensure the felt is ght, secure the top side of felt using CN20 at approx. 100mm intervals. (Detail I3)
• Repeat for remaining felt, working from the low side of roof to the high side, overlapping the felt by 75mm
unl the roof is fully covered.
(Detail I3)
• Fold the overhanging felt at ends under roof board and tack in place.
I1 I2 I3
INCORRECT FELT CORRECT FELT
CN20
CN20
CN20
ROOF BOARD
SECTION 1