To Next PageTo Next PageHow to fix Tiger PDU-A40U Water Heater that does not boil (lamps off, display blank)?
If your Tiger Water Heater does not boil and all the lamps are off and the display panel is blank, the plug might not be connected. Ensure that you connect the plug.
General| Capacity | 40 Liters |
|---|---|
| Power | 2000W |
| Frequency | 50Hz |
| Material | Stainless Steel |
| Thermostat | Adjustable |
| Safety Features | Overheat Protection |
Provides instructions for operating the electric water heater/warmer.
Explains safety symbols and outlines general precautions for safe appliance use.
Details safety precautions related to electrical connections, cord usage, and product operation.
Covers safe handling, preventing spills, immersion warnings, and proper water disposal.
Details the various parts of the appliance, including the lid, handle, and spout.
Explains the controls and display area of the operation panel.
Details the power cord connection and describes normal operational sounds.
Details steps for initial setup, cleaning, and preparation before first use.
Guides the user through the process of filling, connecting, and starting the boiling cycle.
Explains the procedure to remove any chlorine smell from the water.
Guides on how to select and set the desired keep warm temperature.
Explains how to monitor the boiling process and transition to keep warm mode.
Details procedures for re-boiling water and reducing chlorine smell during keep warm.
Guides the user on how to unlock the unit and dispense hot water.
Advises on when and how to refill the water to maintain optimal operation.
Details the steps to manually activate the Energy Saving Mode.
Covers automatic switching, steam cut function, and how to manage the mode.
Guides on how to select and set the desired hours for the power-saving timer.
Explains the procedure to cancel the power-saving timer operation.
Guides on how to safely unplug the unit and remove the lid after use.
Provides instructions for safely discarding any remaining hot water.
Explains how to properly attach the lid after use or cleaning.
Details how to clean the inner container using basic rinsing and wiping methods.
Explains the process for removing mineral deposits using citric acid cleaner.
Guides on cleaning the lid, exterior, power cord, and mesh filter.
Details two methods for removing mineral deposits using citric acid.
Provides instructions on how to prepare the unit for storage if not used for a long period.
Addresses problems such as failure to boil, unusual sounds, and water odors.
Resolves issues related to dispensing, insufficient hot water, and exterior heat.
Solutions for operational issues like dispensing problems, beep notifications, and display fogging.
Explains the meaning of various flashing lamps and error codes on the display.
Lists the technical specifications of the electric water heater models.
Identifies replaceable parts like gaskets, resin parts, and mesh filters with part codes.
Provides step-by-step instructions for removing and attaching the lid gasket.
Details contact information and support channels for parts and service for different regions.
