Tiger TIGERFLEX Elysia

To Next Page

To Previous Page

TIGERFLEX

APEX LOG CABIN GENERAL INSTRUCTIONS

tigersheds.com 0113 205 4189 sales@tigersheds.com

Step 8:

WALL ASSEMBLY STAGE 1

(MODULE PACKS: A, B & Q*)

• For central sections, use notched logs from Module Pack Q, which have a removed section as shown.

(No “Q” pack supplied with 6x6 Models)

• Secure through notch into log below using 1x S40 per notch, then secure into oorboards. Drill pilot hole at an

angle through log into oorboard, then secure in place as shown using 1x S40 per cut log.

(Detail E)

ADDITIONAL STEPS FOR DOOR POSITIONING

OR FULL PANE WINDOWS ON GABLE.

• If you are having a door or full pane window on the end, remove the full log used for boarding the oor and

replace with 2x cut logs as shown. Insert 2x 190mm spacers under the edge of cut logs.

(Detail F)

• Secure through notch into log below using 1x S40 per notch, then secure into spacer. Drill pilot hole at an angle

through log into oor spacer, then secure in place as shown using 1x S40 per cut log.

(Detail G)

Cut Log x 2

Notched Floor Log with

removed section x 4

E F G

S40 S40

190MM SPACER

Tiger TIGERFLEX Elysia - Page 14