Please retain instructions for future reference
17
Step 11:
BUILDING A BLANK WALL
• Start building using 1750mm / 1150mm full logs depending on size of building.
Use supplied construct diagram for reference.
• Secure full bottom log through notch into log below using 1x S40. Drill a pilot hole at an angle through the cut
log into the half log below and screw into place as shown using 1x S40.
(Detail E In Step 8 For Reference)
• Continue to build upwards. Secure built walls using 190mm spacers every ve logs
high using 2x S35.
(Detail H & H1 In Step 9 For Reference)
To Next Page
Loading...
