Tiger TIGERFLEX Elysia - Page 20

Step 13:
ROOF PANEL INSTALLATION
(MODULE PACKS: K/L & T)
• “Hook” roof panels using purlins into notches pre-cut into apex
gable tops.
(Detail M)
• Roof panels should be ush with outer edges of the logs.
(Detail N)
• Use 4x 40mm (S40) equally spaced screws to secure roof panels together
along the purlins.
(Detail M)
• Tie lower edge of roof panels together on both sides of cabin using 190mm spacers.
Secure using 2x35mm (S35) screws per joint.
(Detail P)
• Secure roof to walls and gable tops using the following steps:
• 3x 35mm (S35) screws into gable tops.
(Detail M & P)
• 3x 35mm (S35) screws into side walls. (Detail O)
> Top Tip – use a spirit level to draw a guideline for drilling through into walls.
TIGERFLEX
®
APEX LOG CABIN GENERAL INSTRUCTIONS
20
tigersheds.com 0113 205 4189 sales@tigersheds.com
M
N
O
S35
S35
P
S35
S35
S40
PURLINS