TIGERFLEX
®
APEX LOG CABIN GENERAL INSTRUCTIONS
28
tigersheds.com 0113 205 4189 sales@tigersheds.com
Step 20:
JOINTING FASCIA BOARDS
(MODULE PACKS: N*)
• Secure jointing fascias internally & externally as shown between the side module joins.
Module Packs P to be used on the high side.
• Butt top fascia ush with roof and secure in place using 4x S35.
NOTE: ANGLE EDGE MUST BE AS SHOWN TO STOP WATER INGRESS.
(Detail S)
• Butt bottom fascia board against top fascia board as shown and secure in place using 4x S35. (Detail S & T)
• Repeat for internal fascia boards and remaining exterior fascia board. Secure into 190mm spacers. (Detail U)
*(No N or P packs supplied with 6x6 Models)
S T U
S35
S35
S35
Angle
Edge
Ongoing: As timber is a natural product, any log or board can expand and contract. This may cause slight gapping in the log cabin
which can be rectied by un-screwing and re-screwing jointing fascia boards over the course of the year.
To Next Page
Loading...
