Please retain instructions for future reference
29
Step 21:
FELTING THE ROOF
(MEASURE AND CUT BEFORE INSTALLING THE FELT)
• Roll felt out onto a clean at surface 30 minutes before you need it so it has a chance to atten out.
• Measure length of roof and allow 75mm overhang at each end. Cut each strip of felt to size.
Use a straight edge to guide cutting.
• Roll cut felt piece along low side of roof, Section 1, leaving sufcient overhang to fold down onto roof edge.
NOTE: DO NOT FOLD UNDERNEATH ROOF.
(Detail V1 & V2)
• Once felt is rolled out, x to roof using CN13 at approx. 100mm intervals. (Detail V3) Ensure the felt is tight, then
secure the top side of felt using CN13 at approx. 100mm intervals.
• Repeat for remaining felt, working from the low side of roof to the high side, overlapping the felt by 75mm
until the roof is fully covered.
• Fold the overhanging felt at ends under roof panel and tack in place.
V1 V2 V3
1
C13
CORRECT
FELT
INCORRECT
FELT
To Next Page
Loading...
