09
Please retain instructions for future reference
Step 5:
FLOOR ASSEMBLY
• Measure corner to corner diagonally to make sure cabin oor is square. If both values are equal, your frame
is square. Realign the oor until square. Do not trim.
Step 6:
FLOOR ASSEMBLY
(MODULE PACKS: H/J & Q*)
• From the “Door Board” (see Step 3) work your way across the frame, securing remaining oorboards
using 10x N30 per oorboard.
NOTE: YOU WILL NEED TO REMOVE THE 2 FLOORBOARDS AND LOGS
THAT WERE USED TO HOLD THE FRAME TOGETHER AS YOU COME TO THEM.
• Final oorboard may need to be trimmed. Measure as shown
and cut to size.
(Detail D)
*(No Q pack supplied with 6x6 Models)
1
1
2
2
D
To Next Page
Loading...
