Step 3:
FLOOR ASSEMBLY
(REFERENCE MODEL IS 12X6 THE NOVA 19MM TIGERFLEX LOG CABIN WITH DOOR ON GABLE END.)
• Take full logs and slot them into place as shown. Do not secure with screws.
• For 6x6 models, use 2x full logs.
• For 8x6, 10x6 & 12x6 models, use 3x full logs.
• For 14x6 & 18x6 models, use 4x full logs.
• Decide at this point where you would like your door to be positioned. If you plan to install the door on one of
the gable ends, place your rst oorboard at the door end chosen. This is referred to as the “Door Board”.
Leave approx. 2mm gap at the edges.
08
tigersheds.com 0113 205 4189 sales@tigersheds.com
TIGERFLEX
®
APEX LOG CABIN GENERAL INSTRUCTIONS
Step 4:
FLOOR ASSEMBLY
(MODULE PACKS: H/J & Q*)
• Take 3 oorboards and tack in place as shown below using 5x N30 per oorboard.
NOTE: DO NOT FULLY SECURE AS THESE ARE ONLY TO KEEP THE FLOOR SQUARE
BEFORE INSTALLING REMAINING FLOORBOARDS.
• Align the inner oor bearers so that they are equally spaced across the oor.
*(No Q pack supplied with 6x6 Models)
N30
To Next Page
Loading...
