The instructions for pairing additional door sensors with the Tiiwee alarm system are included in this
manual, or can be found on our website www.tiiwee.com or one of our Youtube channels.
Installation of Door sensors
General guidelines:
• Do not install the sensor near magnets or magnetic devices - this may cause the alarm to be
activated accidentally.
• Clean all surfaces carefully before installation.
• The magnet and sensor should be placed on the door and door frame respectively. The principle
of the system is that an alarm is triggered when the sensor and magnet are separated because the
window or door is opened.
• If possible, mount the sensor on the door frame and not on the door or window itself. This
position reduces the wear and tear that occurs when windows and doors are closed (shocks). It
increases the service life of your sensors.
Installation examples
Various installation examples are shown on the first page of this manual. Make sure that both the
installation surfaces are clean and free from grease and dust. It is essential to respect the maximum
distance of 5 mm between sensor and magnet. Also, please assure that the triangle marks are
aligned.
How to mount a door sensor (please see the inside of the front page)
Image 1: Door and doorpost are at the same level. Position the sensor and magnet next to each other
and position the triangle markers on the sides of the magnet and sensor as such that they are close
to one another.
Image 2: The door is protruding relative to the doorpost. Mount the magnet sideways on the top of
the door and position the sensor with a few millimetres distance on the doorpost and position the
triangle markers on the sides of the magnet and sensor as such that they are close to one another.
Image 3: The doorpost is protruding relative to the door. Mount the sensor sideways on the doorpost
and then position the magnet on the door with a few millimetres distance and position the triangle
markers on the sides of the magnet and sensor as such that they are close to one another.
IMPORTANT - PLEASE NOTE:
• It is essential that the sensor and magnet are aligned correctly and are at the same level using
the triangle marks.
• The distance between the sensor and the magnet should not exceed 5mm.
Magnet:
• Installation with screws: remove the back panel from the magnet by sliding it off. Then, position
the back panel at the desired position. Now, after the magnet back panel has been mounted, put
the magnet on the back panel and slide it downwards until it is in its final position.
• Installation with double-sided tape: peel off the protective foil from one side and stick the tape
onto the magnet. Then, peel off the other part of the protective foil and stick the magnet onto the
door or doorpost.
Sensor:
To Next Page
Loading...
