This is an example of connecting a door sensor to zone 2:
• De-activate the X1-siren by pressing the CONNECT-button on the X1-siren or the
Deactivation-button on the remote control.
• On the X1-siren, press the CONNECT-button for 5 seconds. You hear a beep and all four LEDs
light up.
• On the X1-siren, press the CONNECT-button short two times to select zone 2. The LED of
zone 2 lights up.
• Activate the door sensor by moving the magnet away from the sensor. You hear two beeps,
and the LED of zone 2 blinks twice.
• Save the setting by pressing the On/Off-button on the X1-siren briefly.
The door sensor is now connected to zone 2.
Connecting PIR motion detectors
Proceed as described with the door sensors in the previous chapter. Trigger the device by moving
your hand in front of the motion detector at a distance of 50-70 cm. When performing the pairing
procedure, make sure the motion detector is facing downwards from you to avoid unwanted signals
from the device while pairing it to the X1-siren.
Connecting remote controls
Up to 10 remote controls can be connected to the X1-siren.
Pairing remote controls
▪ Press the CONNECT-button for 5 seconds. You will hear a beep and all four LEDs light up
▪ Press one (any)-button on the remote control(s) which you wish to connect. You will hear two
beeps for confirmation of correct pairing.
▪ Press the On/Off-button shortly to store the settings
The remote control is now connected to the X1-siren.
Adding additional sirens to your system
The system can be expanded with more X1-sirens and A3-outdoor sirens. Just connect your sensors
and remote controls to the new X1 or A3 siren. A new siren operates independently of existing
sirens.
Please refer to the below image which outlines the principle.
To Next Page
Loading...
