IM2019
13
Filter cleaning
To clean the filter, put it in warm water with a mild detergent (with a temperature of about 40° C),
rinse it and remove any dirt. Before installing the filter in the air conditioner, it is necessary to dry
it, avoiding direct sunlight.
Air intakes (heat exchangers)
Use a vacuum cleaner for cleaning
Case
Wipe the surface by a damp cloth and dry it by a soft dry cloth.
Automatic condensate removal
Condensate is automatically removed from the unit. Moisture inside the unit starts to evaporate
and is removed from the unit through an air duct (or an air diffuser) in the form of steam.
Condensate removal instructions
1. When condensate is filling the tank, switch off the air conditioner and turn off the power.
Note: Move the device carefully to avoid spilling of water in the bottom of the case
2. Place the water container behind the outlet at the rear part of the device
3. Unscrew the drain cap and pull out the plug, the water will automatically flow into the water
tank.
Note:
1. Hold the drain plug cover, and the water plug properly.
2. During drainage, the housing may be tilted slightly backwards.
Note: If the water container can’t contain all the condensate from the air conditioner, cover the
drain with a plug as soon as possible to prevent water from spilling onto the floor.
4. When the water is drained, stick water plug and tighten the drain cap.
To Next Page
Loading...
Need help?
General
