TIMBERWOLF Log Splitters Operation Manual
Before You Start the Lo~Splitter
Check Fluids
Location & Setup
• Engine oil should be to the level of the fill pipe.
• Hydraulic oil:
• Timberwolf recommends use of Rando 46 (Texaco) .
• Level should be two inches below the top of the
tank.
• Place log splitter on level ground, in a well lit, well
ventilated spot.
• Check around log splitter for hazards. Make sure there
are no slippery surfaces or objects to trip over in the
,area.
• Make sure there won't be people or animals in the area
around the log splitter.
• Take out cotter pin holding the hitch support leg in the
raised position, swing leg down, and insert cotter pin
in the hole for the down position ..
Vertical • Raising and lowering the log carriage to and from
Setup vertical position requires two people, one on each side
of the machine.
• Finnly block wheels so that log splitter cannot roll in
either direction.
• For best weight distribution, wedge should be fully
extended when raising and lowering log carriage.
• Unclip and remove both the horizontal and vertical
position lock pins.
11
To Next Page
Loading...
