Operation Manual
Maintenance
TIMBERWOLF Log Splitters·
Lh WARNING
Make sure motor is shut off and hydraulic system is depressurized before you
perform any maintenance. Make sure hydraulic oil has cooled. Read "Safety"
section of this manual before performing any repairs.
Engine Oil
Hydraulic Oil
• First change after first 5 hours of operation
• Regular changes after every 20 hours of operation
• Regular changes after every 200 hours of operation
NOTE
If hydraulic oil becomes contaminated it should
be changed immediately.
Hydraulic • The log splitter is equipped with an in-tank, ultra-fine
Oil Filter steel mesh hydraulic oil filter.
• Under normal operating conditions change the filter
after every 1000 hours of operation.
• There is also a green/yellow/red filter condition gauge
mounted on the hydraulic oil tank filler cap.
• Change the filter if gauge approaches the red zone.
18
To Next Page
Loading...
