13
• The Copy function can be used to duplicate Start time/temperature periods,
as detailed further in the instructions (read the instructions in full before
you begin).
10.1 To programme or modify the time/temperature periods, press and hold
the Set button for 3 seconds to enter the programming entry mode.
The display light will illuminate
Press and hold the Set button for 3 seconds
to enter programming mode.
10.2 The Day of the week will flash (e.g. Mon), use the Up/Down arrow
buttons if you need to choose a different day of the week, and then
press the Select button once to confirm
Use the Up/Down arrow
buttons to change
the day of the week
Mon will flash
when selected
Use the Select
button to confirm
10.3 The Prog 1 (period 1) hour will flash, use the Up/Down arrow button to
choose the hour and press the Select button once to confirm.
To Next Page
Loading...
