17
Press the A/M
button once
The blue Learn/Manual
light will illuminate
Press the Learn button
to turn the output ON
and OFF manually
The Red output light
will illuminate when
calling for heat
Manual Override until Next Programme Change
Change (from the Transmitter)
Note: The display shows the current room temperature and correct time.
• Use the Up/Down arrow buttons to change the set temperature,
the display light will illuminate and the Hand symbol will appear
to show the temperature has been manually changed.
Use the Up/Down arrows to
choose the day you wish to copy
the programme to e.g. Wed
The Hand symbol will appear
to show the temperature has
been manually changed
The new set
temperature will
flash while the
change is being
made
• Press the Learn button to turn the output ON and OFF, the red output light
illuminate when calling for heat.
• Press the A/M button once on the receiver to exit, and the blue Learn/
Manual light will turn OFF.
Note: There is no temperature control, only ON or OFF operation from the
receiver, the transmitter will not do anything whilst in this mode.
• The set temperature will flash while the change is being made, and will
time out 15 seconds after the last button is pressed. The display will then
revert to show the current room temperature.
To Next Page
Loading...
