5. Road gate test
5.1 Gate bar position (levelness, verticality) adjustment:
The gate has used the horizontal ruler to adjust the horizontal degree and
verticality as the best position. If the site needs to adjust the position of the
gate rod, adjust according to the following way
1. Gate bar adjustment level (take the left fixing machine as an example)
Long press the menu key, add the parameter item to the P09, and then press the
menu key, you can see the specific parameter value of the P09 item.
If the pole level is high, you can reduce the value, and then press the menu
key to save.(Reducing the parameters of P09 increases the drop rod stroke, making
the swing rod closer to the mechanical limit protection rubber pad, thus reducing
the rod more horizontally.)
If the pole level is low, you can increase the value, and then press the menu
key to save.(Increasing the parameters of P09 reduces the drop rod stroke and makes
the swing rod farther away from the mechanical limit protective rubber pad, thus
raising the rod more horizontally.)
Note: the premise of lowering this value should ensure that the rocker can not
squeeze the mechanical limit pad after the falling rod is in place, and ensure the
2mm gap. If the mechanical limit pad will be squeezed, the parameters should be
increased.As shown in Fig:
To Next Page
Loading...