2. Vertical gate adjustment (take the left fixed machine as an example)
Long press the menu key, add the parameter key to the P10 key, and then press
the menu key to see the specific parameter value of the p10 key.
If the pole is not in place (less than 90 degrees), you can reduce the value,
and then press the menu button to save.(Reducing the parameters of P10 increases
the rod lifting stroke, making the rocking rod closer to the mechanical limit
protective rubber pad, thus raising the rod more vertical.)
If the pole is too far (over 90 degrees), you can increase the value and then
press the menu button to save it.(Increasing the parameters of P10 reduces the stroke
of the lever, making the rocker farther away from the limit protective rubber pad,
thus making the rod lower and more vertical.）
Note: on the premise of lowering this value, ensure that the rocker can not
squeeze the mechanical limit pad after lifting the rod in place, and ensure the 2mm
gap. If the mechanical limit pad will be squeezed, the parameters should be
increased.As shown in Fig:
Note: When the brake rod cannot be shaken to the ideal horizontal or vertical position
by parameter tuning (the mechanical limit block is not in place), adjust the brake
lever position in this way.
Turn the gate and movement open or closed; loosen two loose nuts (M6) on the rocking
lever of the movement, loosen two limit screws (inner hexagonal M6X25), loosen one
locking screw (inner six M12 * 50) for all screws and about 5mm; adjust the lever
to the required position and tighten the loose screw nuts.
7.Digital pipe code meaning
L00: Initial location is not determined
L01: Close the gate in place
L02: Open the gate in place
L03: Stop halfway way
L11: Close the gate
L12: Opening the gate is in the process
E01: The gate is not open in place
E02: The lock machine is not closed in place
E03: The motor direction is not consistent with the setting
E04: Self-test was unsuccessful
E05:, motor blocking rotation
To Next Page
Loading...