4.5 Parameter setting steps:
It can be set by long pressing the Menu / Confirmation button for 3 seconds, and
the LED will display PXX.
Select the menu item by short pressing or long pressing "Lift / +" and "drop / -",
and add one once
Or subtract one, long press is continuous add or subtract.Press Menu again to set
up the specified item and press Stop /
Cancel the key to return to the previous level or exit the settings.When setting
for the specified parameters is complete, you must press " Menu
/ Confirm " key confirmation can not take effect.The parameters set by pressing the
Stop / Cancel key will not take effect.No in 15 seconds
With a button, the buzzer on the control board will ring loudly, exit the setting
state, and return to the normal working state.
4.6 Learning and deletion of remote control coding:
Press the "Lift / +" button in normal working mode to quickly enter the remote control
learning menu command.
1、Paired learning
Entering the remote learning menu item P-22 shows the number of currently
learned.Press any key of the remote control, learn the successful buzzer long sound,
and the LED shows the number of learned remote control plus one, after learning a
remote control can continue to learn the next, the maximum support of up to 200 remote
control.If it is a learned remote control, the buzzer calls rapidly three times
continuously, suggesting that the remote control has been learned.After the study
is completed, press the confirmation key to exit. Then the successful remote control
will have a corresponding response in the normal working state.
2、Clear the remote control
After entering the P-31 menu item, the number of currently learned remote
controls is displayed. Press confirm key to clear all learned remote controls, and
the number of remote controls is 0.
4.7 DC brushless gate controller command list:
To Next Page
Loading...