Changing the Display Format
You have the option of viewing either the lap or split time
in the large digits in the center of the watch display. The
display format can be changed at any time, though the
method changes based on whether or not laps have been
taken. The word “LAP” will appear on the display to inform
you where the lap time is displayed.
If no laps have yet been taken:
Press SET. “FORMAT” will appear on the display, followed
by the current configuration, which will be flashing. Press
START/SPLIT or STOP/RESET to select the desired format
and then press SET to save the setting and return to the
Chronograph display.
pressing and holding STOP/RESET.
You may leave CHRO mode while the Chronograph is run-
ning; it will continue to run in the background, indicated by
the icon on the display when in TIME mode.
Lap/Split Timing
Press START/SPLIT each time you pass a segment marker
(like trail head marker) to complete the timing of the
previous lap or segment and begin timing a new one. The
lap and split times for the segment just completed will be
displayed for ten seconds (it will still be timing the new
segment in the background, indicated by the flashing
symbol on the display). If you wish to return to the running
Chronograph immediately, press MODE to dismiss the
previous lap time data.
To Next Page
Loading...
Need help?
General
