2. Press START/SPLIT to view each successive lap/split
time, followed by the BEST and AVERAGE lap
(if the Chronograph is stopped). You may also press
STOP/RESET to go back and view earlier lap/split
times.
NOTE: You may recall the stored timing information while
the Chronograph is running or stopped, as long as you
have taken at least one lap. If the Chronograph is stopped,
the BEST and AVG information will follow the last entry; if
the Chronograph is still running, these data are not shown.
3. When you have finished reviewing the lap/split times,
press SET to return CHRO mode.
NOTE: You may also change the display format for CHRO
mode while viewing stored lap/split information. Press
If you have taken at least one lap:
Press SET. “RECALL” will appear on the display, followed by
the lap and split times for Lap 1. Press MODE – “FORMAT”
will appear on the display followed by the current display
format configuration, which will be flashing. Press
START/SPLIT or STOP/RESET to select the desired format
and then press SET to save the setting and return to the
Chronograph display.
Reviewing Stored Lap/Split Times
1. In CHRO mode, press SET to begin. If there are
lap/split times stored, “RECALL” will appear on the
display, followed by the lap/split time for Lap 1.
NOTE: If there are no lap/split times to recall, the watch
will display “FORMAT” and allow you to change the display
format (see “Changing the Display Format” above).
3938
To Next Page
Loading...
