98
99
Interrupting the countdown sequence: If you wish
to stop the countdown sequence prior to the sequence
reaching zero, you may do so by pressing button A (the
fourth center hand as well as the upper and lower hands
will stop moving). If you wish to later begin the sequence
from the point at which you stopped the countdown, sim-
ply press button A again (the fourth center hand as well
as the upper and lower hands will resume moving).
Resetting the countdown sequence: Once the count-
down sequence has reached zero and the chime has
sounded, you may reset the countdown timer to the set
value by pressing button B (the fourth center hand as well
as the upper and lower hands will move to indicate the
value of time you set prior to using the countdown timer
function).
Clearing the countdown timer value: If desired, you
may clear the value of the countdown timer to zero.
This can only be done if the countdown timer is not in
operation and has been reset. If the countdown timer is
running, you must first stop the countdown sequence by
pressing button A, followed by pressing button B. This
will stop and reset the countdown timer to the currently
selected time value. To clear the countdown timer value
to zero, push and hold button B for two seconds. You
should now follow the instructions to set the countdown
timer value to the new desired length of time.
To Next Page
Loading...
Need help?
General
