Operating the Radio
1. Press the Radio Button once to turn on the radio. The display will show “On” before returning to the
clock display. The bottom of the display will show the digital radio frequency.
Note: If the Radio Button is pressed more than once, the unit will enter the sleep mode, with the radio
operating on a timer. See Sleeping to Radio with Timer for more information about this feature.
2. Press the Band Button to select a radio band. There are two different FM bands (to be used when
programming preset radio station settings) and one AM band.
3. Press the Reverse/Tuning or Forward/Tuning Button to find a station to listen to. To scan the
radio stations, hold a button for about three seconds. The radio will rapidly advance to the next strong signal.
4. You may also use the Radio Memory Set Buttons to select a preset radio station. See the Programming
Radio Station Memories section for instructions on programming radio station settings.
5. Adjust the volume using the Volume Buttons.
6. Press the
Off/Reset Button to turn the radio off. The bottom of the display will show the calendar setting.
Programming Radio Station Settings
The radio features 18 programmable radio station settings so you can access your favorite stations quickly.
1. Tune to the first station you wish to program into your preset station settings.
2. Press and hold one of the six Radio Memory Set Buttons to program the station into that memory
slot. When the unit beeps, the station setting has been saved.
3. Continue programming a total of 18 stations into memory: six each into the two FM bands and six into the
AM band. To edit a setting, simply program a new frequency into the memory slot.
Antenna Information and Adjustment
FM – Extend the FM wire antenna to its full length and vary the direction to its strongest signal.
AM – The AM bar antenna is located inside the cabinet. Rotate the unit until you find the strongest AM signal.
Last Station Memory
The tuner always remembers the last station selected before the radio was switched off, and automatically selects
the station again when the radio is turned on.
Listening to the Radio
12
To Next Page
Loading...
Need help?
General
