13
Operating the Alarms
This clock radio features a triple alarm system, with three alarms that can be operated independently. Alarm-1
features a choice of a CD tracks or a beeping alarm sound, Alarm-2 features a radio alarm wake sound, and
Alarm-3 features a nature wake sound. You can set any combination of the three alarms. In addition, each
alarm features a 7-5-2 setting that lets you set the alarm in advance for a full week, the workweek, or the weekend.
Setting Alarm-1 for CD Track or Beeping Alarm Sound
1. Press and hold the Alarm-1 Button until the Alarm-1 settings and Wake Track Indicator appear on
the flashing display. The display will flash for ten seconds before returning to the standard clock display.
2. Press the
Reverse or Forward Button to set the Alarm-1 time. Holding a button for a few seconds
will advance or reverse the time rapidly. Be sure to set the correct AM/PM time, as shown by the PM
Indicator on the display.
3. After setting the Alarm-1 time, insert a CD into the CD Player and use the Wake Track Button to select
the track that will play at the set time. To wake to a beeping alarm sound, leave the CD Player empty. Adjust
the volume using the Volume Buttons.
4. After setting the wake time and sound, you will need to select your 7-5-2 setting. The 7-5-2 setting lets you
set the alarm for a full week, weekdays only, or the weekend. Before setting the alarm, be sure that you have
set the correct date, as shown in the Setting the Calendar section of
this manual. While the display is still
flashing, press the
Date Set/7-5-2 Button
until the desired setting is shown at the top of the display.
5. After you have programmed the Alarm-1 settings, press the Enter Button or wait ten seconds to return
to the clock display. The Alarm-1 Indicator will appear on the display, showing that the alarm is set.
Setting Alarm-2 for AM/FM Radio
1. Press and hold the Alarm-2 Button until the Alarm-2 settings and radio frequency appear on the display.
2. Press the
Reverse or Forward Button to set the Alarm-2 time.
3. Use the Band Button and the Memory Set Buttons to select a radio station to wake to. For more
information on programming radio stations into memory, see the Programming Radio Station Settings section
of this manual. Adjust the volume using the Volume Buttons.
4. See Note #4 in the previous section for instructions on setting the 7-5-2 alarm setting for Alarm-2.
5. After you have programmed the Alarm-2 settings, press the Enter Button or wait ten seconds to return
to the clock display. The Alarm-2 Indicator will appear on the display, showing that the alarm is set.
To Next Page
Loading...
Need help?
General
