Need help?Do you have a question about the Tippmann X7 Basic and is the answer not in the manual?
Emphasizes user's responsibility for safe operation and familiarization.
Instructs to keep the barrel sleeve installed when not shooting.
Explains how to activate and deactivate the trigger safety mechanism.
Encourages familiarization with safety precautions for responsible use.
Details initial preparation before installing the air supply cylinder.
Provides instructions for attaching and securing the air supply cylinder.
Guides on installing and preparing the hopper and feeder system.
Explains how to adjust the marker's velocity using an Allen wrench.
Describes how to adjust the rear sight for aiming accuracy.
Details on cleaning, aligning, and securing the hopper and feeder mechanism.
Explains using an Allen wrench to adjust velocity by turning a screw.
Instructs on rotating the rear sight adjuster to correct impact point.
Details connecting the air supply cylinder, checking for leaks, and troubleshooting.
Explains using an Allen wrench to adjust velocity by turning a screw.
Explains how to adjust the rear sight for firing high or low impact points.
Instructions for detaching the lower receiver assembly from the upper receiver.
Details how to disconnect the gas line and tombstone from the upper receiver.
Step-by-step guide for removing and reinstalling internal drive assembly parts.
Instructions for disassembling the upper receiver halves.
General| Caliber | .68 |
|---|---|
| Weight | 3.5 lbs |
| Length | 20 inches |
| Operating Pressure | 800 PSI |
| Power Source | CO2 or Compressed Air |
| Construction | Aluminum |
| Action | Semi-Automatic |
| Body Material | Composite |
| Fire Modes | Semi-Automatic |
| Type | Mechanical Paintball Marker |
| Feed System | Hopper |
| Firing Rate | 15 BPS |
To Next Page
