16
Telephone calls
Switching between handset and hands-free operation
You are holding a telephone conversation using the handset and want to switch to the hands-
free operation:
You are holding a conversation in the hands-free mode and now want to use the handset:
1. Press the button and keep it
pressed.
2. Replace the handset.
3. Release the button.
1. Pick up the handset.
The hands-free mode is activated.
The hands-free mode is deactivated and you
can continue holding your telephone conver-
sation via the handset.
1. Press the button.
2. Press the button again.
The symbol "mute" is displayed. The handset
microphone and the hands-free microphone
are deactivated. You can now make your
enquiry in the room.
The handset and the hands-free microphone
are activated again. You can continue with
the telephone conversation.
Headset-operation
It is possible to connect the tiptel headset (item no. 3054110) instead of the handset. This makes
telephoning in the office even more comfortable. Remove the curled cable of the handset from
the corresponding receptacle and replace it by the relevant headset connecting cable. The hand-
set can either be removed or remain on the telephone.
The function "connection set-up" must have been assigned to one functional key (refer to chapter
macro programming).
You receive an incoming call:
1. Press the key "connection set-up".
2. At the end of the telephone call, press
the key "connection set-up" anew.
You make an outgoing call:
1. Press the key "connection set-up".
2. Enter the phone number.
3. At the end of the telephone call, press
the key "connection set-up" anew.
The call is accepted via the headset.
The call is being disconnected.
The headset is switched on.
The telephone starts dialling.
The call is being disconnected.
Mute function
When holding a telephone conversation you can make a confidential enquiry in the room with-
out allowing your telephone partner to listen to what is spoken.
To Next Page
Loading...
