TIPTEL 83 system - Factory Pre-Set

35
System settings
Factory pre-set
You can resume the factory pre-set parameters at any time.
1. Press the  or  button to select
"settings".
2. Press the  button.
3. Press the  or  button to select
"system".
4. Press the  button.
5. Press the  or  button.
6. Press the  button.
T
o resume the factory pre-set:
7. Press the  button.
T
o interrupt:
7. Press the  button.
Every time you press the button, the display
switches between the available functions.
The display shows "appointments".
The display shows "system".
The display shows "ISDN".
The display shows "factory pre-set".
The warning message "ATTENTION! All data
are erased" is shown in the display.
The factory pre-set is resumed.
The function is interrupted (the data are
retained).