TIPTEL IP 286 - Page 27

27
www.tiptel.nl
Tiptel b.v.
Camerastraat 2
1336 BC Almere
Tel: 036 53 666 50
Fax: 036 53 678 81
404 means 404 (Not Found)
480 means 480 (Temporarily not
available)
486 means 486 (Busy here)
The default is 480.
Refuse_Code
404, 480 or
486
It defines the value of Return code
when refuse.
404 means 404 (Not Found)
480 means 480 (Temporarily not
available)
486 means 486 (Busy here)
The default is 486.
DND_On_Code
String
It defines DND On Code.
The default is blank.
DND_Off_Code
String
It defines DND Off Code.
The default is blank.
ButtonSoundOn
0 or 1
It defines whether to enable dialing
tone.
0 stands for Disabled.
1 stands for Enabled.
The default is 1.
[ AutoRedial ]
path = /config/Features/Phone.cfg
EnableRedial
0 or 1
It defines whether to enable/disable
Auto redial.
0 stands for Disabled.
1 stands for Enabled.
The default is 0.
RedialInterval
Integer
from 1 to
300
It defines the value of Auto redial
interval.
The default is 10 (seconds).
RedialTimes
Integer
from 1 to
300
It defines the value of Auto redial
times.
The default is 10.
[ PoundSend ]
path = /config/Features/Phone.cfg
Enable
0,1 or 2
It defines the Key As Send.
0 stands for Disabled.
1 stands for # key.
2 stands for * key.
The default is 1.
[ Emergency ]
path = /config/Features/Phone.cfg
Num
Phone
numbers
separated
by commas
It defines the Emergency numbers
separated by commas. For example,
it can be specified
as:911,999,110,120
The default is blank.
[ memory1 ]
path = /config/vpPhone/vpPhone.ini
type
blf or bla
It is used when configuring a DSS
Key as BLF or Shared Line.
blf stands for BLF.