7.0 - Installation / Replacement of Battery & Fuse Protection
WARNING:
● To avoid electric shock, disconnect the test leads from any source of voltage before removing
the back cover or the battery or fuse covers.
● To avoid electric shock, do not operate the meter until the battery and fuse covers are in
place and fastened securely.
Battery Installation / Replacement.
To avoid the false readings, replace the battery as soon as the battery indicator
appears.
1) Turn power off and disconnect the test leads from the meter.
2) Open the rear battery cover.．
3) Insert the battery into battery holder, observing the correct polarity．
4) Put the battery cover back in place & secure.
Replacing the Fuse(s)
1) Turn power off and disconnect the test leads from the meter.
2) Remove the battery cover and the battery.
3) Remove the screws securing the rear cover.
4) Remove the defective fuse and install an identical fuse. (F200mA or F10A Fuse)
5) Replace and secure the rear cover, battery and battery cover.
To Previous Page