120V High Amperage Digital Humidity Controller
• Warnings and Cautions
• Factory Settings
• Eos
®
120V High Amperage Digital Humidity Controller Overview
• Instructions for Operation
• Error Codes
• Controller Specifications
• Controller Diagrams
• Installation Options
• Installation Example
• Warranty Information
• Service & Repair Program
Warnings & Cautions
• Read all instructions before operating controller.
• Do not put your controller in an area where it can get
wet or sprayed.
• Mount your controller securely to the wall.
• When using “bug bombs” in area, cover controller and sensor completely to avoid corrosion.
• There are no serviceable parts in controller. Do not attempt to repair the unit.
• Breaking tamper proof seal will void your warranty.
• Do not put paper clips, tools, etc. into unit. Possible electrocution may occur.
• Plug controller into surge protector to avoid potential damage to the unit.
• Confirm that your power source is 120 Volts/20 Amps prior
to plugging controller into outlet.
• Check that all equipment that will be activated by this controller is the proper voltage.
• Verify that the equipment you are controlling does not exceed a total of 20 amps.
• This controller is designed for “inside use” only.
• Use caution if operating controller in extremely humid environments (90% rH and above).
• Do not use controller for purposes other than the unit was designed to function.
• Use controller within defined environmental specifications.
• Ask your Dealer fo
r tips and techniques regarding the use of this controller.
• Be conscientious when disposing of any products.
2
To Next Page
Loading...
Need help?
General
