TPM 057 Version 1.0, May 30, 2018 Page | 2
INTRODUCTION
2 INTRODUCTION
This manual provides information specific to the Titan Logix Corp. TD100
TM
Level Gauge and Overfill
Prevention System (hereafter referred to as the TD100) only.
Installation and operational information pertaining to optional equipment or peripheral systems will not
be included in this manual. Refer to the vendor supplied documents for more information or go to
www.support.titanlogix.com for Titan Logix online documents.
This guide is intended to assist the user on the installation, use, and maintenance, of the Titan Logix
TD100, under normal working conditions. Any user performing installations or operations outside the
scope of this guide, are advised to contact Titan Logix technical support.
It is essential that this manual be read and understood for proper installation and operation of your new
TD100 system.
2.1 W
ARRANTY
Please see the Terms and Conditions at http://www.titanlogix.com/products.aspx for details about
product warranty.
2.2 D
ISCLAIMER
The information in this document is subject to change without notice. Titan Logix Corp. makes no
representations or warranties with respect to the contents hereof.
2.3 P
ROPRIETARY
I
NFORMATION
The Information disclosed herein contains proprietary rights of Titan Logix Corp. Neither this document
nor the information disclosed herein shall be reproduced or transferred to other documents, or used or
disclosed to others for manufacturing purposes, or for any other purpose except as specifically
authorized in writing by Titan Logix Corp.
2.4 S
AFETY
This manual will use the following standard safety terms and conventions to indicate conditions:
WARNING
Indicates a hazardous situation which, if not avoided, could result in death or serious
injury.
To Next Page
Loading...