Titan CONTROL PRO 190 - Check for Suction

SPRAY
PRIME
3  4X
FIGURE 1
FIGURE 2
TAP WITH A MALLET
FIGURE 3
SPRAY
PRIME
3  4X
WATER
12 OZ
EN
7
CHECK FOR SUCTION
i



www.wagnercontrolpro.com/howto
YOU WILL NEED
• 
• 
• 
FIGURE 1: CHECK FOR SUCTION
1. 
2. 
3.            

  

  
FIGURE 2: TAP THE OUTLET
1. 
2.             

3. 
4. 
  

  
FIGURE 3: USE WATER TO FREE THE OUTLET VALVE
1. 
2. 
3. 
4. 
5.      
Note:
After every use, this procedure should be repeated with some
light household oil. See “Long Term Storage” section in the
instruction manual.