Titan TTB579PLN User Manual

11
TTB579PLN by TITAN
Technical and legal
information
Getting started...
GB
IE
by the manufacturer or his agent in order to avoid a safety hazard.
24. For tools intended to be connected to a water supply
> For tools provided with a PRCD: Never use the tool without the PRCD
delivered with the tool,
> For tools provided with an isolating transformer: Never use the tool without
the transformer delivered with the tool or of the type as specified in these
instructions.
> Replacement of the plug or the supply cord shall always be carried out by the
manufacturer of the tool or his service organisation,
> Keep water clear off the electrical parts of the tool and away from persons in
the working area.
HEALTH ADVICE
Warning! When drilling, sanding, sawing or grinding, dust particles will be
produced. In some instances, depending on the materials you are working
with, this dust can be particularly harmful to you (e.g. lead from old gloss paint).
You are advised to consider the risks associated with the materials you are working
with and to reduce the risk of exposure. You should:
- Work in a well-ventilated area.
- Work with approved safety equipment, such as those dust masks that are specially
designed to filter microscopic particles.
SPECIFIC SAFETY INSTRUCTIONS
Caution! If used incorrectly, woodworking machines can be dangerous, for
this reason always comply with the safety instructions mentioned in this
manual.
> Never work without the protective equipment prescribed for the relevant
operation and do not make any modifications to the machine that could
undermine safety.
> Children and young persons must not operate this machine. This rule does not
apply to young persons over the age of 16 being trained and supervised by an
expert.
> Prior to all work, make sure that the safety and operating equipment is securely
attached. Any parts, if damaged must be repaired correctly or replaced.
> Set up the machine on a firm flat surface so that the table is horizontal and the
machine cannot tip over.
> Never work with pieces which are too big or too small for the machine’s
capacity.
>
Before planing, examine the workpiece for metal objects and stones and remove
them if necessary.

Titan TTB579PLN Specifications

General

Brand	Titan
Model	TTB579PLN
Category	Planer
Language	English