EN
25
In more detail...
TTB820GGT by TITAN
Trimming Line feeding
During use, the tip of the trimming lines (12d) will get shorter due to wear and the
trimming line may break. Regularly check the condition of the trimming lines (12d)
and adjust if necessary.
3. Pay special attention when performing the work close to trees and bushes.
The cutting head could damage sensitive bark, and damage fence posts.
4. Pull the plant protector (13) out to avoid bringing the cutting device into contact
with hard objects such as walls and kerbstones (Figs. 21, 22).
NOTE: The trimming line will wear faster and require more
replacement if cutting is done along sidewalks or other abrasive
surfaces or heavier weeds are being cut.
NOTE: While trimming, the cutting device is possible to be blocked
by grass or unevenly ground. So the product will turn off automatically
due to over current. Therefore release the on/off switch for over 3s
and then press down again to go on with trimming.
Operation
Fig. 21 Fig. 22
WARNING! Always switch the product off, disconnect the product
from the power supply and let the product cool down before
performing inspection, maintenance and cleaning work!
NOTE: This product is equipped with an auto-feed head. Do not bump
the trimmer head on the ground as this would damage the product.
To Next Page
Loading...
Need help?
General
