Titan TTB960STP - Page 27

EN
27
EN
In more detail...
TTB960STP by TITAN
Operation
General operation
1. Check the product, the charger cable and power adaptor as well as accessories
for damage before each use. Do not use the product if it is damaged or shows
wear. Take care of any problem you nd or have the product checked by
qualied specialist.
2. Double check that the accessories and tool attachments are properly xed.
3. Always hold the product on the handle grip (5). Keep the handle dry to ensure
safe operation.
4. Ensure that the air vents (3 / 7a) are always unobstructed and clear. Clean
them if necessary with a soft brush. Blocked air vents may lead to overheating
and damage the product.
5. Switch the product off immediately if you are disturbed while working by other
people entering the working area.
6. Do not overwork yourself. Take regular breaks to ensure you can concentrate
on the work and have full control over the product.
7. While working, ensure that the product does not strike hard objects, as this
can cause damage.
Checking
NOTE: Before operating the product, perform the following tests to
check the function of the safety yoke (9) and the main trigger (4).
1. Remove the staples out of the magazine (8).
2. Switch the product on and the power indicator
(1) will turn green.
3. Press the safety yoke (9) onto the soft
wooden pad, then squeeze the main trigger
(4) for ring. The safety yoke (9) and the
main trigger (4) should move smoothly. The
ring should be performed.
4. If any malfunctions occur, stop to use the
product immediately and turn to the dealer
for repair.
B
C
A
9a
9
Fig. 9
NOTE: There is a gap between the safety yoke (9) and the shot duct
(9a). Make several trials to staple at your desired position (Fig. 9).
MNL_3.6 V Cordless 12mm Stapler_V2_230628.indd 27 6/28/23 5:43 PM