Titan TTB960STP - Page 29

EN
29
EN
In more detail...
TTB960STP by TITAN
Operation / Care and maintenance
After use
1. Release the main trigger (4) and the safety yoke (9), switch the product off
and let it cool down.
2. Remove the staples out from the magazine (8).
3. Check, clean and store the product as described below.
The golden rules for care
WARNING! Always switch the product off and let the product cool
down before performing inspection, maintenance and cleaning work!
1. Keep the product clean. Remove debris from it after each use and before
storage.
2. Regular and proper cleaning will help ensure safe use and prolong the life of
the product.
3. Inspect the product before each use for worn and damaged parts. Do not
operate it if you nd broken and worn parts.
WARNING! Only perform repairs and maintenance work according to
these instructions! All further works must be performed by a qualied
specialist!
General cleaning
1. Clean the product with a damp cloth and pH-neutral soap. Use a brush for
areas that are hard to reach.
2. In particular clean the air vents (3 / 7a) after every use with a cloth and brush.
3. Remove stubborn dust with high pressure air (max. 3 bar).
NOTE: Do not use chemical, alkaline, abrasive or other aggressive
detergents or disinfectants to clean this product as they might be
harmful to its surfaces.
4. Check for any damage and wear. Repair damages in accordance with this
instruction manual or take it to an authorised service centre before using the
product again.
MNL_3.6 V Cordless 12mm Stapler_V2_230628.indd 29 6/28/23 5:43 PM