Titan TTBPP52 - Page 28

28
TTBPP52
In more detail . . .
Engine warm start
1. Set the lever (7) to the Start (I) position (Fig. 14).
2. Set the choke lever (22) to the RUN position (Fig. 15).
7
15
22
14
3. Pull the recoil starter handle (19) slowly until you feel a denite resistance and then
give it a brisk, strong pull. Repeat until the engine starts.
4. To start operation, squeeze the throttle trigger (8) and lock it at the position between
Start (I) and full throttle by the setting/stop lever (7) for the desired working speed.
Stopping the engine
1. Release the throttle trigger (8) and let the machine run in idle for a while.
2. Set the stop lever (7) anti-clockwise to the STOP position.
WARNING! The machine continues to work for some time even after the
engine has been stopped! Wait until it comes to a complete stop before you
put the machine down!
Operation