Titan TTBPP52 - Page 32

32
TTBPP52
In more detail . . .
Removing blockages
WARNING! Wear safety gloves when removing blockages! Use proper tools
to remove debris, e.g. a wooden stick! Never use bare hands!
Ensure the engine is off by setting the setting/stop lever (7) to STOP position
before disconnecting the hose or tubes for any maintenance or for removing
blockage.
1. Place the machine on an even surface and remove the exible hose (5), extension
tube with handle holder (9), extension tube (10) and nozzle (11) in reverse order of
assembly.
2. Check the parts for blockages. Carefully tap the parts to loosen the blockage.
3. Check the openings on the motor unit for blockages. Remove them with a suitable
damp tool or wooden stick if required.
Maintenance
Inspect and maintain this machine regularly based on below maintenance table. Keep
the chain saw in good working condition during maintenance.
Part Task Before/after
each use
Every 10 hours
of operation
Every 25 hours
of operation
Spark plug
check X
clean X
replace whenever necessary
Spark
arrestor
screen on
the mufer
check X
clean whenever necessary
replace whenever necessary
Air lter
check X
clean X
replace whenever necessary
Fuel lter
and fuel
lines
clean whenever necessary
replace whenever necessary, or every 2 years
Tubes and
hoses
check X
clean X
Silencer
clean every 100 hours of operation
replace whenever necessary
Care and maintenance