Titan TTHTP26 - Page 30

30
TTHTP26
In more detail . . .
> Apply a small amount of suitable lubricant on the cutting device (1) to retain a good
cutting performance (Fig. 27).
>
Tighten loose nuts on the cutting device (1) with a proper wrench (with 5 Nm to
7 Nm) to ensure safe operation (Fig. 28).
27
28
Maintenance table
Inspect and maintain this equipment regularly based on below maintenance table. Keep
the equipment in good working condition during maintenance.
Part Task Before/after
each use
Every 10 hours
of operation
Every 25 hours
of operation
Spark plug
check X
clean X
replace whenever necessary
Air lter
check X
clean X
replace whenever necessary
Fuel lter
and fuel
lines
clean whenever necessary
replace whenever necessary
Gear box lubricate X
Cutting
device
check X
lubricate X
clean X
replace/
sharpen
whenever necessary
Care and maintenance
5059340124346-TTHTP26-GB-V01.indd 305059340124346-TTHTP26-GB-V01.indd 30 18/9/2020 9:55 AM18/9/2020 9:55 AM