To Next PageTo Next Page
Need help?Do you have a question about the Titan Xi445 and is the answer not in the manual?
General| Brand | Titan |
|---|---|
| Model | Xi445 |
| Category | Paint Sprayer |
| Language | English |
High pressure paint stream can pierce skin, leading to serious injury or amputation.
Solvent and paint fumes can explode or ignite. Ensure ventilation and avoid ignition sources.
Inhaling or contact with paints, solvents, etc., can cause severe health effects.
Avoid materials containing bleach or chlorine as they react with aluminum.
Follow all instructions and safety precautions to prevent injury or damage.
Use a proper grounding extension cord of adequate gauge and length.
Proper grounding is essential to reduce the risk of electric shock.
Lists items included in the sprayer's shipping carton.
Explains the operation of the ON/OFF switch, knobs, and tubes.
Details capacity, power source, and safety features of the sprayer.
Visual guide to identify sprayer components like the gun, hose, and cart.
Illustrates the spray gun, guard, and tip components for identification.
Steps for assembling the cart handle and connecting the spray hose.
Instructions for installing the suction tube and inlet filter onto the pump.
Procedures for locking and unlocking the spray gun trigger for safety.
Steps to safely relieve pressure from the spray hose before servicing.
Safety measure for grounding the gun when using oil-based materials.
How to purge test fluid from new units using separating oil and spray material.
Adjusting pressure control and PRIME/SPRAY knob for priming.
Process to purge air, water, or solvent from the spray hose.
Instructions for correctly inserting and tightening the spray tip and guard.
Turning on the pump, setting controls, and checking the spray pattern.
Guidance on gun angle, distance, and stroke overlap for best results.
Steps to clear a clogged spray tip using the CLEAN position and pressure.
Procedure to remove, clean, and reassemble the spray gun filter.
Steps to remove and clean the filter at the bottom of the suction tube.
Instructions to remove, clean, and reassemble the main sprayer filter.
General advice on cleaning with water or mineral spirits, and proper disposal.
Step-by-step guide for cleaning the sprayer with latex materials and a garden hose.
Detailed steps for flushing the system with water after initial rinse.
Procedure for cleaning the sprayer using mineral spirits for oil-based materials.
Steps to remove, clean, and reassemble the suction hose, return tube, and inlet filter.
Instructions for removing and cleaning the spray gun filter, tip, guard, and saddle seat.
Steps to safely shut down the sprayer for short-term storage (up to 16 hours).
Steps to restart the sprayer after short-term storage.
Procedure for preparing the sprayer for extended periods of non-use using separating oil.
Steps to remove, clean, and reassemble the Sureflo™™ valve for priming issues.
Identifies causes and provides solutions for the sprayer failing to power on.
Identifies causes and provides solutions for the sprayer not drawing paint during priming.
Identifies causes and provides solutions for pressure loss when the spray gun is operated.
Identifies causes and provides solutions for a distorted or 'tailing' spray pattern.
Lists and identifies parts for the spray gun assembly with part numbers.
Lists and identifies parts for the suction set with part numbers.
Lists and identifies parts for the cart assembly.
Lists various optional accessories compatible with the sprayer.
Details the limited warranty for the spray equipment against defects in material and workmanship.
Outlines warranty exclusions, liabilities, and specific consumer rights.
