TKSTAR LK106 - Initial Setup and Basic Operation; SIM Card Installation; Battery and Charger; Startup Procedure

5
5.1 SIM card installation
Make sure that there is no call transfer and call display is on, and PIN code off. The SMS message must in Text
format, can’t be identified for PDU format.
5.1.1 Open the rear cover, remove the screws by screwdriver.
5.1.2 Forward push and open the metal piece, put the SIM card into the card slot, and press the metal piece to
its original position, push it backward.
5.2Battery and Charger
Do charge the battery to capacity in 8 -12 hours for first time. Please use the battery and charger provided by
the manufacturer. This unit adopts built-in Li-ion battery, and full battery can standby 80 hours. After first use,
the battery usually should be charged fully in 3-5 hours.
Cautions:
a: For it’s Li-ion battery, which contains harmful chemicals and may burst, please don’t bump, puncture it
violently and keep it off fire.
b: Please charge the battery in time to keep it working normally.
5.3Startup
 Put the SIM card and battery in place.
 Turn on the unit outdoors by pressing the “on/off” button until the indicator is on.
 For first use, please initialize the unit and restore it to default setting. (Please refer to 5.4 for instruction.)
 In 10 or 40 seconds, the unit will begin to work and acquire the GSM signals as well as the GPS signals.
The indicator will keep flashing every 3 seconds when the unit has received the signals.
 When this unit receives GPS signals normally, you can use it and do any setting as the instructions of this
manual.
green LED for GPRS working status
Status of indicator Meaning
Slow flash (flash 1s after every 2s) GSM / GPRS conversation start
Continuously in bright status No GPRS signal
Green Led off
Device fault or dormant
Blue LED for GPS working status
Status of indicator Meaning
Slow flash (flash 1s after every 2s) GPS location successful
Continuously in bright status Searching GPS signal
Blue led off
Device fault or dormant
Red LED for power charging status
Status of indicator Meaning
Red led on all the time
Charging
red led flash
Low battery
red led off Full battery or charged full