Toast Flex - Toast Flex: Standalone Setup; Unpacking and Connecting Cables; Setting Up Payment Devices

14
Unpack the Toast Flex terminal and place the terminal
on your counter.
Remove the yellow box labeled “Connect.” This box
contains two yellow ethernet cables. One cord is 3 ft and
one is 7 ft. Choose the cord length that best suits your
restaurant and connect it from the wall to the yellow port
labeled “Internet IN” on the base of the Toast Flex
terminal stand.
Remove the orange power box labeled “Power.” Plug in
the power cord from the wall into the orange port located
at the base of the Toast Flex terminal stand. Use the
thumb screw to secure it. Ensure the thumbscrew is
tight to avoid connectivity issues.
Set up payment using one of the options below:
Toast Flex
1
2
3
4
B
A
If you are attaching your Toast Tap (On-Counter)
to the Toast Flex, open the purple box labeled
“Payments.” This box contains your Toast Tap
(On-Counter). Follow the instructions in the
printed guide for Micro USB to Micro USB.
If you have Toast Tap (Direct Attach to Toast
Flex), this will already be adhered to your Toast
Flex terminal.
Step 3 Step 2
Thumb
Screw
Step 3 Step 2